Insert the tab into the middle groove and tighten the green knobs. Adjust the stop to your desired measurement.
This system allows for repeatable parallel cuts without manually measuring and marking each piece.
: When using an MFT/3 Multi-Function Table, ensure the guide rail is long enough to clear the board at both the start and end of the cut to prevent kickback. 4. Alternatives & Enhancements Festool Parallel Guides UwzCWe4JQ2VYrg4oyh4
: Always start with a clean "reference edge" by trimming the factory edge of your plywood before making parallel cuts.
: Recommended for ripping 8-foot sheets or edge-jointing lumber up to 9 feet. It provides a single, perfectly straight reference edge that is more reliable than connecting two shorter rails. Insert the tab into the middle groove and
: The standard for cross-cutting 4-foot sheets.
Selecting the correct length is critical to ensure the saw is fully supported during the entire cut. : When using an MFT/3 Multi-Function Table, ensure
: If you must connect two rails, use Guide Rail Connectors. While functional for long rips, a single long rail is always more accurate.