Glafirae015_058.jpg May 2026

: Layout all parts from the box. Compare your hardware (screws, bolts, shims) against the parts list in your manual. Chassis/Frame Base : Attach Mounts to the ends of the crossbar channels.

Fasten these crossbars to the main side channels (typically at specific holes like hole 2 and 9). : Slide Bearings and Shims onto your shafts. GlafiraE015_058.jpg

The (e.g., Strafer Chassis, a specific desk name, or vanity)? : Layout all parts from the box

Check for "slack"—if the shaft slides too much, move the 6mm shim to the other side of the bearing. Fasten these crossbars to the main side channels

The specific file name appears to be an internal image reference for a set of assembly instructions, likely for a furniture or mechanical kit. Based on standard assembly guides for similar products (such as those from IKEA or goBILDA ), you can follow this general "Put Together" workflow: 🛠️ General Assembly Workflow

💡 : If your build has "wobble" (common in vanities or furniture), use a shim to level the base before fully tightening the top. To help you find the exact manual, could you share: The brand or manufacturer of the item?

Install , ensuring the built-in shim is oriented correctly according to the diagram.