768 Zip | Download V56 General 1024

If power is interrupted during the flashing process, the board may become "bricked" and require an external SPI programmer to recover.

Flashing this firmware usually follows a standard "USB Upgrade" method: A USB drive must be formatted to FAT32 . Download V56 General 1024 768 zip

Pre-configured parameters for voltage (3.3V, 5V, or 12V), LVDS signaling (Single Channel 6-bit or 8-bit), and remote control codes. Installation Procedure If power is interrupted during the flashing process,

can result in a "No Signal," "Out of Range," or distorted display. Installation Procedure can result in a "No Signal,"

Insert the drive into the board's USB port while the power is off. Turn on the power; the indicator LED will usually blink rapidly, indicating the update is in progress.

The .bin file from the zip must be placed in the root directory of the USB drive (not inside a folder).

Once the LED stops blinking or stays solid, the power is cycled, and the board should boot with the resolution settings. Safety and Risk Warnings